Nano Fiber Sediment Filter 0.2 micron 20" x 4.5"

SKU
CFpltn-20BB
$179.95
Specifications

Ultra clean water is one of the most important needs of our bodies. Why settle for bad tasting water when you can use our high-efficiency nanofiber filters.

Whole House Sediment Water Filter - NanoCeram® Electropositive NanoFiber Filter -- 0.2 micron - 20" x 4.5"

  • Fine 0.2 micron absolute pleated sediment water filter.
  • Electropositive material removes virtually all suspended particles.
  • Removes 99.9% viruses, bacteria, cryptosporidium, giardia, turbidity, fine silt, clay, and rust particles.
  • Also reduces some ionic metals, such as Fluoride, by up to 50% @ 5gpm
  • High flow, low pressure loss <1psi
  • Fits Home Master Water Filter, and 20" Big Blue water filter housings

NanoCeram® Electropositive NanoFiber Filters

NanoCeram® NanoFiber is combined into a microglass fiber matrix to form an electropositive (~+50 mV) filter media and is then formed into pleated cartridges. The active ingredient is a nano alumina fiber that is only 2 nanometers in diameter and about 250 nm long and is grafted to a microglass fiber backbone. Coarser cellulose or synthetic polymer fibers are added to enlarge the pore size and provide flexibility and strength. The media is produced by a conventional wet laying process and is then pleated and capped to form a cartridge. Since virtually all small particles are electronegative when present in water, they are readily adsorbed and bound to the filter media. This filter has a high efficiency for capturing very fine particles.

Electrokinetic adsorption is used for filtering particles from both air (“electrets”) and water. Most colloidal (suspended) particles in water are negatively charged as a result of differences in electrical potential between the water and the particle phases. This charge is due to an unequal distribution of ions over the particle surface and the surrounding solution. Since the NanoFiber material is electropositive they bond with the filter effectively removing virtually all suspended particles from the water.

Operating Conditions:

  • Feed water: PSI 20 - 100 PSI
  • Feed water Temperature: 40˚ - 100˚F
  • Max. Total Dissolved Solids (TDS): 2000 ppm
  • pH limits: 4 - 10

* Your results may vary depending on regular maintenance, general condition of the filtration unit, and initial water conditions.

Write Your Own Review
You're reviewing:Nano Fiber Sediment Filter 0.2 micron 20" x 4.5"
Your Rating
© 2024 The Perfect Water. All rights reserved