Membrane Housing with Membrane and Fittings -- Fully Assembled
Home Master reverse osmosis membrane housing with premium reverse osmosis membrane, 1/4" stainless steel check valve, flow restrictor, 1/4" drain fitting, and 1/4" inlet fitting -- fully assembled.
Time To Change your RO Membrane?
it been 3-5 years?
Simplify your membrane change service -- order this replacement RO membrane pre-assembled in the membrane housing with your replacement filter change set
Its like getting a brand new purification unit.
Overview of Options:
RO Membrane - Replacement RO membrane for your Home Master® Reverse Osmosis System.
Dow Filmtec 50 gpd 98% NaCL removal
Dow Filmtec 75 gpd 99% NaCL removal - best for harder water
Dow Filmtec 100 gpd 98% NaCL removal*
CSM Brand 150 gpd 93% NaCL removal - best for low pressure*
*This will fit in an undersink Home Master RO, but it is intended for use with the gardening systems.
Add Filters Select desired model/filters for a complete refresh of your Home Master® Reverse Osmosis System to ensure the best possible water quality. UV, Ultra, and HydroPerfection also get a new UV Filter housing and bulb.
Add new Full Contact hardware with your Artesian or HydroPerfection System for a simpler installation.
Alternatively, select "Customer Reuse Existing DIY" and transfer your existing Full Contact hardware to the new cluster when it arrives at your home. The tubing will be configured to accept your Full Contact hardware.
Select "Not Present / Remove" if you do not have or want Full Contact hardware.
Add a new Permeate Pump to reduce water waste, increase production, and reduce TDS creep.
Alternatively, select "Customer Reuse Existing DIY" and transfer your existing Permeate Pump to the new cluster when it arrives at your home. The tubing will be configured to accept your Permeate pump.
Select "Not Present / Remove" if you do not have or want a Permeate Pump.
Tubing - Upgrade your Home Master® Reverse Osmosis System with Biosafe Antimicrobial Tubing. Designed to inhibit microbial colonization on the tubing's inner surface; this tubing prevents the formation of biofilm and polymer slime that can cause poor taste, odors, and material degradation.
Feed water: PSI 40 - 100 PSI
Feed water Temperature: 40˚ - 100˚F
Max. Total Dissolved Solids (TDS): 2000 ppm
pH limits: 4 - 10
* Your results may vary depending on regular maintenance, general condition of unit, and initial water supply. Filter not designed to treat microbially unsafe or non-potable water with out adequate disinfection before and after unit.